Tile Adhesive

CL 11

Commercial grade, self-levelling compound

CL 11 has been especially designed to produce a smooth, flat surface when applied to hard, rigid sub-floors such as cement sand screeds, concrete, etc. CL 11 contains high quality special cements and selected fillers so that, when mixed with water, it produces a free flowing mortar with self-levelling properties. The mortar can be applied at a thickness from 3 – 5mm and suitable for internal areas only.

• Pumpable: highly fluid for fast installation
• Self-smoothing: produces flat and absorbent surface for subsequent finishes
• Walkable after 3 hours
• Ready to receive floor coverings within 48 hours

Approximately 5.0 m² @ 3 mm thickness

25 kg

ARDEX P 7

Ready-to-use Primer for Non-Absorbent Substrates

ARDEX P 7 Primer is designed for use on internal floors. The consistency of ARDEX P 7 Primer has been optimised so that dripping and splashes are virtually eliminated. For use prior to the installation of ARDEX ENDURA tile adhesives and floor-levelling compounds. ARDEX P 7 Primer produces a textured grip which facilitates tile on tile application, eliminating the risk of adhesives slipping when being applied to smooth surfaces.

• Ready mixed re-sealable tub for convenience and ease of use
• Rapid drying – dries in as little as 30 minutes
• Pink colour allows clear identification of primed areas
• Moisture resistant – for internal use
• Produces a textured grip surface
• For use with ARDEX ENDURA tile adhesive sand floor levelling compounds
• Suitable for a wide range of non-absorbent smooth, dense substrates
• Solvent free according to TRGS 610
• Classified as EMICODE EC1 PLUS: Very low in emissions

Approximately 80-120 m²

12 kg